基于圖像處理的型坯直徑非接觸測量方法研究

　　4 結論

　　通過攝像機直接拍攝型坯輪廓圖像，運用數字圖像處理技術對采集到的圖像進行處理和分析，實時提取目標的幾何特征，即型坯的直徑分布，可實現型坯直徑的實時在線檢測。但其測量精度會受一些條件的影響，如圖像采集設備的分辨率、光線環境及干擾等。本文針對型坯直徑分布的在線檢測問題進行了討論，它將為實現擠出吹塑成型加工過程質量的實時監控和閉環控制提供可能。

　　參考文獻

[1] R.W. Diraddo and A. Garcia - Rejon. Noncontact Measurement of Parison Thickness Profiles Affected by Swell and Sag in ConTInuous Extrusion Blow Molding [J]. Polymer Engineering and Science. 1992, 32(19) : 1401～1410.
[2] R.W. Diraddo and A. Garcia - Rejon. On - Line Prediction of Final Part Dimensions in Blow Molding: A Neural Network Computing Approach [J]. Polymer Engineering and Science. 1993, 33(11): 653-664.
[3] P.L. Swan and M. R. Kamal. Optical On - line Measurement of the Thickness Distribution of Blow Molding Parisons[J]. Polymer Engineering and Science. 1996, 36(7) : 985-992.
[4] R.W. Diraddo, W. I. Patterson, and M. R. Kamal. On ? line Measurement and Estimation of Parison Dimensions in Extrusion Blow Molding[J]. Advances in Polymer Technology. 1998, 8 (3) : 265～274.
[5] 余煜松，周源華，吳時光．?dāng)?shù)字圖象處理[M]．北京：電子工業出版社，1989．
[6] 鄭南寧．計算機視覺與模式識別[M]．北京：國防工業出版社。1998．