新聞中心

        EEPW首頁 > 嵌入式系統 > 設計應用 > 基于SAA1160A設計的嵌入式USB主控制方案

        基于SAA1160A設計的嵌入式USB主控制方案

        作者: 時間:2010-06-08 來源:網絡 收藏
        器,和 Rev. 2.0兼容,支持全速(12Mbps)和低速(1.5Mbps)數據傳輸。提供兩個下行端口,每個端口有過流(OC)檢測輸入引腳和電源開關輸出引腳。工作電壓3.3V或 5.0V,主要用在PDA,數碼相機,3G手機,STB,信息電器(IA),照片打印機,游戲臺等。本文介紹了主要特性和優勢,方框圖,采用內部和外部OC的檢測電路以及和Hitachi SH-3 (SH7709) RISC處理器的接口電路。

        SAA1160A Embedded host controller

        The SAA1160A is an embedded Universal Serial Bus (USB) Host Controller (HC) that complies with Universal Serial Bus Specification Rev. 2.0, supporting data transfer at full-speed (12 Mbit/s) and low-speed (1.5 Mbit/s). The SAA1160A provides two downstream ports. Each downstream port has an OverCurrent (OC) detection input pin and power supply switching control output pin. The downstream ports for the HC can be connected with any USB compliant USB devices and USB hubs that have USB upstream ports.

        The SAA1160A is well suited for embedded systems and portable devices that require a USB host. The SAA1160A brings high flexibility to the systems that have it built in. For example, a system that has the SAA1160A built in allows it to be connected to a device that has a USB upstream port, such as a USB printer, USB camera, USB keyboard, USB mouse, among others.

        SAA1160A主要特性和優勢:

        Complies with Universal Serial Bus Specification Rev. 2.0

        Supports data transfer at full-speed (12 Mbit/s) and low-speed (1.5 Mbit/s)

        Adapted from Open Host Controller Interface Specification for USB Release 1.0a

        Selectable one or two downstream ports for HC

        High-speed parallel interface to most of the generic microprocessors and Reduced Instruction Set Computer (RISC) processors such as:

        Hitachi SuperH SH-3 and SH-4

        MIPS-based RISC

        ARM7, ARM9 and StrongARM

        Maximum 15 MB/s data transfer rate between the microprocessor and the HC

        Supports single-cycle and burst mode DMA operations

        Built-in FIFO buffer RAM for the HC (4 kB)

        Endpoints with double buffering to increase throughput and ease real-time data transfer for ISOchronous (ISO) transactions

        6 MHz crystal oscillator with integrated PLL for low EMI

        Built-in software selectable internal 15 kΩ pull-down resistors for HC downstream ports

        Dedicated pins for suspend sensing output and wake-up control input for flexible applications

        Operation at either +5 V or +3.3 V power supply voltage

        Operating temperature range from 40℃ to +85℃

        Available in an LQFP64 package (SOT314-2)

        SAA1160A 應用:

        Personal Digital Assistant (PDA)

        Digital camera

        Third-generation (3-G) phone

        Set-Top Box (STB)

        Information Appliance (IA)

        Photo printer

        MP3 jukebox

        Game console


        圖1。SAA1160A方框圖
        linux操作系統文章專題:linux操作系統詳解(linux不再難懂)

        上一頁 1 2 下一頁

        評論


        相關推薦

        技術專區

        關閉
        主站蜘蛛池模板: 华蓥市| 望都县| 龙门县| 蚌埠市| 长岛县| 建水县| 望江县| 聂拉木县| 双桥区| 旬阳县| 调兵山市| 南昌县| 县级市| 西城区| 亳州市| 红原县| 颍上县| 东丽区| 浑源县| 滦平县| 那曲县| 思茅市| 郁南县| 西峡县| 曲阳县| 富源县| 新龙县| 康平县| 岚皋县| 虎林市| 清新县| 高邑县| 即墨市| 六枝特区| 阜南县| 政和县| 慈利县| 崇礼县| 尚志市| 翼城县| 武清区|