如何使用STATECAD進行多狀態機設計實例分析
加入技術交流群
ELSE
Next_sreg1=M0readwait;
Readcounter = (( Std_logic_vector''(Readcounter1, Readcounter0)));
END IF;
WHEN Read0 =>
IF ( Readcounter0=''1'' AND Readcounter1=''1'' ) THEN
Next_sreg1=M0empty;
Readcounter = (Std_logic_vector''("00"));
ELSE
Next_sreg1=Read0;
Readcounter = (( Std_logic_vector''(Readcounter1, Readcounter0)) +
Std_logic_vector''("01"));
END IF;
WHEN STATE1 =>
IF ( (Sreg=M0full)) THEN
Next_sreg1=Read0;
Readcounter = (( Std_logic_vector''(Readcounter1, Readcounter0)) + Std_logic_vector''("01"));
ELSE
Next_sreg1=STATE1;
Readcounter = (( Std_logic_vector''(Readcounter1, Readcounter0)));
END IF;
WHEN OTHERS =>
END CASE;
評論