如何將System generator與MATLAB進行匹配？

EDK 7.1i

R14 SP1, R14 SP2 and R14 SP3 from MathWorks

Windows XP

System Generator for DSP 7.1

PC Only ISE 7.1i Service Pack 1 or later

ChipScope 7.1i

EDK 7.1i SP2

R14, R14 SP1, R14 SP2 from MathWorks

Windows XP

System Generator for DSP 6.1

PC Only ISE 6.3i Service Pack 1 or later

IP Update 4

ChipScope 6.3i

EDK 6.3i

R13 SP1 or R14 from MathWorks

For information on installing System Generator for DSP 6.1.1 with ISE 6.2i, see (Xilinx Answer 18964)

Windows XP

System Generator for DSP 3.1

PC Only ISE 5.2i Service Pack 1 or later

R13 from MathWorks

Synplify 7.2

Leonardo Spectrum 2002e

Windows 2000 and Windows XP

System Generator for DSP 2.3

PC Only ISE 5.1i

IP Update 1

R12 SP1 or R13 from MathWorks

Synplify 7.2

Leonardo Spectrum 2002d

Windows NT 4.0 Service Pack 6, Windows 2000, and Windows XP

System Generator for DSP 2.2

PC Only ISE 4.2i

IP Update 2

R12 SP1 from MathWorks

Synplify 7.1

Leonardo Spectrum 2002a

Windows NT 4.0 Service Pack 6 or greater, Windows 2000, and Windows ME

System Generator for DSP 2.1

PC Only ISE 4.1i Service Pack 1 or later

IP Update 1

R12 or R12 SP1 from MathWorks

Windows NT 4.0 Service Pack 6 or greater, Windows 2000, and Windows 98

System Generator for DSP 1.1

PC Only ISE 3.xi Service Pack 7 or later

IP Update 3

R11 SP1 or R12 from MathWorks

Windows NT 4.0 and Windows 98

System Generator for DSP 1.0

PC Only ISE 3.1i Service Pack 1 or later

IP Update 1 (d_ip1)

R11 SP1 from MathWorks

Windows NT 4.0 and Windows 98

也可以參考 如果安裝好了system generator(安裝ISE套件的時候一般會一起安裝的)和相應的MATLAB后還需要做如下操作方能成功使用system generator 1、打開“我的程序 ——> Xilinx Design Tools——> Xilinx Design Suit 14.2——>system generator MATLAB Configurator出現如下界面

一開始出現的是no configured，Xilinx Suite選擇IDS，并在前面方框勾上，并確保MATLABD的安裝路徑是正確的，注意MATLAB的安裝路徑不能出現中文和空格。最后點擊Apply，稍等一會...Status就會出現Configured。 說明system generator和MATLAB已經關聯成功!