Operating Power Supplies in Series 電源串聯工作

Although some users

are nervous about operating power supplies in series,

it is common practice in the industry.

The benefit is that voltages greater than 60V can be obtained using off-the-shelf

products.

盡管某些用戶對電源的串聯工作存在擔心，這在行業的使用中是一種普遍現象。其優點在于，成品電源采用串聯方式可獲得超過 60V 的電壓。

It is possible to

connect several power supplies in series, but please read the precautionary

notes below:

可以將多臺電源進行串聯，但請事先仔細閱讀以下說明：

·

Connect back-biased

diodes across the power supply terminals as shown below.

·

如下圖所示，在電源輸出端子之間連接反向偏置二極管。

Output 輸出

Power

Supply 1 電源 1

Power

Supply 2 電源 2

Load 負載

Rate these diodes at the same output current as the power

supplies.

外加保護二極管的額定電流不得小于電源的額定輸出電流。

In the event both power supplies do not turn on at the

same time, or if the load becomes a short circuit, then the diodes will protect

the power supplies from any applied reverse voltage.

當兩臺電源不是同時啟動或者負載發生短路時，二極管可以保護電源免受外部任何施加的反向電壓的影響。

·

Do not

exceed the output to ground/chassis voltage rating. Inside most power supplies are noise filter

capacitors connected from the output to ground.

It is possible to exceed the operating voltage of those capacitors,

particularly when configuring several units in series.

·

請不要超出輸出到地/外殼的電壓允許值。大部分電源內部都具有從輸出連接至接地端的噪聲濾波電容器。尤其是當多臺電源串聯運行時，這些電容器上的工作電壓可能會超出允許值。

·

Avoid

using “fold-back style” current limited power supplies as these may lock up the

power supply during initial switch on.

·

避免使用過流保護模式為“關斷式”的電源，因為可能會在初次打開時電源被鎖定。