利用MAXQ3210產生壓電信號

通過改變循環計數器LC[0]裝載的數值來改變輸出頻率(對應于產生的音符)。通過改變循環計數器LC[1]裝載的數值來改變音符持續時間。把這些代碼打包到一個簡單宏中，定義幾個常數，就很容易產生播放一小段音樂的代碼。

#define NOTE_C     261#define NOTE_C_SH  277#define NOTE_D_FL  277#define NOTE_D     294#define NOTE_D_SH  311#define NOTE_E_FL  311#define NOTE_E     330#define NOTE_F     349#define NOTE_F_SH  370#define NOTE_G_FL  370#define NOTE_G     392#define EIGHTH     1       ; 120 beats per minute, 4/4 time#define QUARTER    2       ; 120 beats per minute, 4/4 time#define QUARTERDOT 3       ; 120 beats per minute, 4/4 time#define HALF       4       ; 120 beats per minute, 4/4 time#define WHOLE      8       ; 120 beats per minute, 4/4 timeplay macro note, durationlocal L1, L2move    HRNC,  #1move    LC[1], #(note * duration / 8)L1:move    PO0.0, #1         ; Switch output high.move    LC[0], #(1785000 / note)djnz    LC[0], $          ; Decrement and jump, if not zero, to current ;    instruction.move    PO0.0, #0         ; Switch output low.move    LC[0], #(1785000 / note)djnz    LC[0], $          ; Decrement and jump, if not zero, to current ;    instruction.djnz    LC[1], L1         ; Decrement and jump, if not zero, to top of loop.move    HRNC,  #1move    LC[1], #50        ; 50ms of silenceL2:move    LC[0], #3570      ; 1ms (inner loop)  djnz    LC[0], $djnz    LC[1], L2endm
				
            

				
					
					
				
			
                
			
							

                
			            

                            	              			              			              			上一頁
	              			              			1
              		              			              		              	              				              				2
              					              				              			              		              	              				              				3
              					              						              						              				下一頁